2Pcs PCA9685 16 Channel 12-bit PWM Servo Motor Driver Board I2C interface Controller PCA9685 module Raspberry Pi Shield Module Servo Shield

Description

Instructions for use: Drive board connected to board: The PWM driver board uses the I2C method, so only four lines can be connected to the board: device: “Classic” board: pin mode: +5V -> VCC GND -> GND Analog 4 -> SDA Analog 5 -> SCL R3 and later board: pin method (These boards have dedicated SDA and SCL pins) +5V -> VCC GND -> GND SDA -> SDA SCL -> SCL VCC pin is only for the chip power supply, if you want to connect the servo or LED lights, use the V + pin power supply, V + pin supports 3.3 ~ 6V power supply (chip safe voltage 5V). It is recommended to connect the external power supply via the power supply terminal. power supply part: Most of the servo design voltage is 5 ~ 6V, especially in a number of steering gear at the same time running, with the need for high-power power supply. If you are directly using the board: 5V pin to power the servo directly, there are some unpredictable problems, so we recommend that you have a suitable external power supply for the drive board. Connect the servo: Most servos are connected using standard 3-wire female plugs, as long as the corresponding pin into the driver board on it. (Ground wire is generally black or brown, the signal line is generally yellow or white) for the driver board assigned address: Each drive board of the cascade needs to have a unique access address. The initial I2C address of each driver board is 0 40, you can modify the upper right corner of the jumper I2C address. Connect a jumper with solder to indicate a binary number “1”. Package include: 2 x PCA9685 IIC module